Skip to the main content

Technical gazette, Vol. 27 No. 1, 2020.

Original scientific paper

https://doi.org/10.17559/TV-20161102131118

Some Aspects of the Three-Dimensional Interface Cracks Analysis

Jelena M. Djoković orcid id orcid.org/0000-0001-5542-8088 ; Technical Faculty in Bor, University of Belgrade, V. Jugoslavije 12, 19210 Bor, Serbia
Ružica R. Nikolić orcid id orcid.org/0000-0003-3042-8916 ; Research Center, University of Žilina, Univerzitna 1, 010 26 Žilina, Slovakia
Jan Bujnak ; Research Center, University of Žilina, Univerzitna 1, 010 26 Žilina, Slovakia
Branislav Hadzima ; Research Center, University of Žilina, Univerzitna 1, 010 26 Žilina, Slovakia
Radoljub Tomić orcid id orcid.org/0000-0001-9898-8237 ; University "Union - Nikola Tesla", Faculty for Strategic and Operational Management, Staro sajmište 29, 11070 Belgrade, Serbia

Full text: english pdf 1.081 Kb

page 1-4

downloads: 885

cite

Abstract

Many problems of interfacial cracks are three dimensional in nature. Three-dimensional cracks at an interface of the two materials are analysed in this paper. For a crack at an interface, the stress intensity factors, load phase angle and energy release rate depend on elastic characteristics of two bonded materials and on geometry and the load conditions of a bimaterial sample. Influence of Dundurs' parameters on stress intensity factors, load phase angle and energy release rate for different bi-material combinations and for the quarter-circular corner crack are discussed in this paper. Results show that elastic properties of materials constituting the interface have significant influence on behaviour of the 3D interface crack. Mode I stress intensity factor KI increases when the crack front approaches the free surface, while KII remains almost constant having the highest values between 10° and 80°, what results in high values of the load phase angle. The KIII stress intensity factor is zero in the symmetry plane, while its value increases as the crack front approaches free surfaces. The energy release rate diagrams show that the crack of a quarter circular front propagates faster closer to free surfaces than in the middle what means that the crack front would have the tendency of straightening.

Keywords

Dundurs' parameters; interface cracks; load phase angle; stress intensity factors; three-dimensional cracks

Hrčak ID:

234071

URI

https://hrcak.srce.hr/234071

Publication date:

15.2.2020.

Visits: 1.991 *