Skoči na glavni sadržaj

Tehnički vjesnik, Vol. 19 No. 1, 2012.

Prethodno priopćenje

The task of 5-axis milling

Peter Pokorný ; Slovak University of Technology, Faculty of Materials Science and Technology, Bottova 25, 917 24, Trnava, Slovak Republic
Jozef Peterka ; Slovak University of Technology, Faculty of Materials Science and Technology, Bottova 25, 917 24, Trnava, Slovak Republic
Štefan Václav orcid id orcid.org/0000-0003-3266-3645 ; Slovak University of Technology, Faculty of Materials Science and Technology, Bottova 25, 917 24, Trnava, Slovak Republic

Puni tekst: hrvatski pdf 290 Kb

str. 147-150

preuzimanja: 1.353

citiraj

Puni tekst: engleski pdf 290 Kb

str. 147-150

preuzimanja: 1.340

citiraj

Sažetak

The article deals with 5-axis milling. This milling method is currently used in manufacturing of complex shaped parts. The 5-axis milling achieves increased accuracy of components because it is possible to mill a component from five sides at one clamp. The description of 5-axis milling machines structures is also mentioned as well as the equations for the calculation of important parameters of a hemispherical milling cutter. These parameters are adjusted for 5-axis milling. Finally, effective cutting speed and effective feed rates exploitation in practice are summarized.

Ključne riječi

effective cutting speed; effective feed rat; 5-axis milling; structures of milling machines

Hrčak ID:

79171

URI

https://hrcak.srce.hr/79171

Datum izdavanja:

29.3.2012.

Podaci na drugim jezicima: hrvatski

Posjeta: 3.934 *