Metalurgija, Vol. 53 No. 4, 2014.
Izvorni znanstveni članak
Analysis of residual stresses on the transverse beam of a casting stand by means of drilling method
P. Frankovský
; Faculty of Mechanical Engineering, Technical University of Košice, Slovakia
F. Šimčák
; Faculty of Mechanical Engineering, Technical University of Košice, Slovakia
Sažetak
The presented paper demonstrates the application of drilling method in the analysis of residual stresses on the transverse beam of a casting stand. In the initial stage of the analysis the determination of strains was done for individual steps of drilling in the area which was determined by means of numerical analysis. The drilling was carried out gradually by 0,5 mm up to the depth of 5 mm, while the diameter of the drilled hole was 3,2 mm. During the analysis we used the drilling device RS-200, strain indicator P3 and SGD 1-RY21-3/120. The paper presents the development of residual stresses throughout the depth of the drilled hole which were determined according to standard ASTM E837-01, by means of integral method, power series method and by means of Power Series method.
Ključne riječi
residual stress; casting stand; drilling method; SGD 1-RY21-3/120
Hrčak ID:
122179
URI
Datum izdavanja:
1.10.2014.
Posjeta: 846 *