Tehnički vjesnik, Vol. 23 No. 2, 2016.
Izvorni znanstveni članak
https://doi.org/10.17559/TV-20150109133006
3D-layouts of machine tools for multipurpose machining of rotary components
Lachezar Stoev
; Technical University of Sofia, Faculty of Industrial Technology, Faculty of German Engineering Education and Industrial Management, 8 Kl. Ohridski Blvd., 1000 Sofia, Bulgaria
Stoil Bozhikov
; Technical University of Sofia, Faculty of Industrial Technology, 8 Kl. Ohridski Blvd., 1000 Sofia, Bulgaria
Sažetak
In the paper is presented a concept for design of different 3D-layouts of one- and two-carriage machine tools for combined machining of chuck and centre to centre type workpieces based on a modular principle. New 3D-layouts are offered for consecutive or simultaneous, one-sided or bilateral machining of chuck and centre-to-centre type components. The first section of the paper presents design features and technological capabilities of typical representatives of the so-called single-carriage machine tools as 3D-layouts. The second section presents typical 3D-layouts of double-carriage machine tools where two parallel guideways are used for guiding each one of the carriages. The effective integration of the rough and finishing machining can be accomplished only by new machine tools for chuck or centre-to-centre type workpieces referred in the present paper as "multipurpose".
Ključne riječi
3D-layouts; multipurpose machining; one- and two-carriage machine tools
Hrčak ID:
156816
URI
Datum izdavanja:
27.4.2016.
Posjeta: 3.129 *