The interaction and synergic effect of particle size on flotation efficiency: A comparison study of recovery by size, and by liberation between lab and industrial scale data

Authors

  • Fatemeh Kazemi Ph.D. student of mineral processing, Faculty of Engineering – University of Kashan, Kashan - Iran. https://orcid.org/0000-0002-9564-1016
  • Ataallah Bahrami Urmia University
  • Yousef Ghorbani MiMeR – Minerals and Metallurgical Engineering, Luleå University of Technology, SE-971 87 Luleå, Lulea - Sweden. https://orcid.org/0000-0002-5228-3888
  • Abolfazl Danesh Complex of Copper Processing – Sungun, East Azerbaijan Province, Headquarters Rd, Tabriz – Iran.
  • Morteza Abdollahi Ph.D. student of mineral processing, Faculty of Engineering, Isfahan University of technology, Isfahan – Iran.
  • Hadi Falah BSc student of mineral processing, Department of Mining Engineering, Faculty of Engineering, Urmia University, Urmia – Iran.
  • Mohsen Salehi BSc student of mineral processing, Department of Mining Engineering, Faculty of Engineering, Urmia University, Urmia – Iran.

DOI:

https://doi.org/10.17794/rgn.2023.1.1

Keywords:

Flotation, recovery, particle size distribution, copper, mineralogy

Abstract

The interaction and synergic effect of particle size on flotation efficiency were investigated by a comparison study between laboratories (size-by-size flotation modes) and industrial scale operational data (whole mixed size fraction). For this purpose, sampling was done from the feed, concentrate, and tailing of the flotation rougher cells of the Sungun copper processing complex (located in the northwest of Iran). In the size-by-size flotation mode (lab scale), the sample was first subjected to different size fractions, and then flotation tests were performed for each fraction. On an industrial scale, the particle size distribution of feed, concentrate, and tailing of flotation of the rougher stage have been analyzed. According to the results, in the case of industrial flotation mode (whole mixed size fraction), the particles with d80=84 μm were more likely to reach the tailing of flotation, and the particles within the size range of +63-180 μm constituted the highest amount of concentrate particles. In lab flotation mode (size-by-size), the maximum recovery was in the size fraction of +40-60 μm. By comparing the two flotation modes of industrial (whole mixed size fraction) and lab (size-by-size), for fractions <45 μm, the industrial flotation recovery was approximately 40% greater than the lab flotation recovery. However, for fractions >125 μm, the recovery trend was reversed and the lab flotation recovery was greater than the industrial flotation recovery. Coarse particle flotation has significant economic and technological benefits. By improving the recovery of coarse particles during the flotation process, the amount of grinding requirements will be reduced and consequently, it will considerably decrease the amount of energy consumption.

Downloads

Published

2023-03-06

How to Cite

Kazemi, F., Bahrami, A., Ghorbani, Y., Danesh, A., Abdollahi, M., Falah, H., & Salehi, M. (2023). The interaction and synergic effect of particle size on flotation efficiency: A comparison study of recovery by size, and by liberation between lab and industrial scale data . Rudarsko-geološko-Naftni Zbornik, 38(1), 1–12. https://doi.org/10.17794/rgn.2023.1.1

Issue

Vol. 38 No. 1 (2023): No. 62

Section

Mining

License

Copyright (c) 2023 authors

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

Creative Commons-BY

Authors who publish with this journal agree to the following terms:

In agreeing this form, you certify that:

  1. You read the ethical codex of the RGN zbornik available at journal web.
  2. You submitted work is your original work, and has not previously been published and does not include any form of plagiarism.
  3. You own copyright in the submitted work, and are therefore permitted to assign the licence to publish to RGN zbornik.
  4. Your submitted work contains no violation of any existing copyright or other third party right or any material of an obscene, libellous or otherwise unlawful nature.
  5. You have obtained permission for and acknowledged the source of any illustrations, diagrams or other material included in the work of which you are not the copyright owner.
  6. You have taken due care to ensure the accuracy of the work, and that, to the best of your knowledge, there are no false statements made within it.
  7. All co-authors of this submitted work are aware of, and in agreement with, the terms of this licence and that the submitted manuscript has been approved by these authors.

 

Publication licence

You retain copyright in your submitted work, according to journal license policy (CC-BY). By signing this form you agree that RGN zbornik may publish it under the publication licence. In summary the licence allows the following:

Anyone is free:

  • To copy, distribute, display, and perform the work.
  • To make derivative works.

 

Under the following conditions:

  • The original author must always be given credit.
  • The work may not be used for commercial purposes.
  • If the work is altered, transformed, or built upon, the resulting work may only be distributed under a licence identical to this one.

 

Exceptions to the licence

In addition to publishing the work printed under the above licence, RGN zbornik will also enable the work to be visible online.

The journal editorial can change the licence rules anytime but it cannot retroactively restrict author(s) rights.