Skoči na glavni sadržaj

Izvorni znanstveni članak

https://doi.org/10.5552/drind.2011.1041

Welding Time as an Important Factor of Beech Welding

Ivica Župčić ; Šumarski fakultet Sveučilišta u Zagrebu, Zagreb, Republika Hrvatska
Andrija Bogner ; Šumarski fakultet Sveučilišta u Zagrebu, Zagreb, Republika Hrvatska
Ivica Grbac ; Šumarski fakultet Sveučilišta u Zagrebu, Zagreb, Republika Hrvatska


Puni tekst: hrvatski pdf 232 Kb

str. 115-121

preuzimanja: 1.255

citiraj


Sažetak

Bonding of wood by virtue of wedge, without any adhesives and welding, has been done for centuries. If such wedge (in this research wood dowels) are rotated during the bonding with the surface (in controlled conditions) at certain parameters, a firm joint is formed. Welding of wood is a process where chemical and physical reactions take place, heat is formed during the friction that melts and softens the structure of wood, and a firm joint is formed by cooling of the melt. The paper shows world findings so far, as well as the results of our own research of the influence of welding process on the dowel embedded force between the beech wood dowel and the beech surface. The joints with the best results concerning the dowel embedded force (4994 N) were the joints where the process of impressing wood dowels lasted from 0.56 to 0.9 s (with each turn of the wood dowel, the movement was 1.41 to 0.88 mm) and the lowest dowel embedded force (2869 N) was recorded when the duration of the impressing lasted from 1.81 to 2.61 s. The average embedded force of glued spirally grooved dowels amounts to 5028 N.

Ključne riječi

welding of beech; welding time; strength of the welded joint; dowels; embedded force

Hrčak ID:

69457

URI

https://hrcak.srce.hr/69457

Datum izdavanja:

20.6.2011.

Podaci na drugim jezicima: hrvatski

Posjeta: 2.711 *