Repair Welding of Titanium Alloy Construction
; Sveučilište u Splitu, Fakultet elektrotehnike, strojarstva i brodogradnje, Spllit, Hrvatska
Igor GABRIĆ orcid.org/0000-0003-3707-1091
Puni tekst: hrvatski pdf 2.488 Kb
APA 6th Edition
ŽIVKOVIĆ, D., GABRIĆ, I. i ŠITIĆ, S. (2011). Repair Welding of Titanium Alloy Construction. Strojarstvo, 53 (4), 319-319. Preuzeto s https://hrcak.srce.hr/80457
MLA 8th Edition
ŽIVKOVIĆ, Dražen, et al. "Repair Welding of Titanium Alloy Construction." Strojarstvo, vol. 53, br. 4, 2011, str. 319-319. https://hrcak.srce.hr/80457. Citirano 09.06.2023.
Chicago 17th Edition
ŽIVKOVIĆ, Dražen, Igor GABRIĆ i Slaven ŠITIĆ. "Repair Welding of Titanium Alloy Construction." Strojarstvo 53, br. 4 (2011): 319-319. https://hrcak.srce.hr/80457
ŽIVKOVIĆ, D., GABRIĆ, I., i ŠITIĆ, S. (2011). 'Repair Welding of Titanium Alloy Construction', Strojarstvo, 53(4), str. 319-319. Preuzeto s: https://hrcak.srce.hr/80457 (Datum pristupa: 09.06.2023.)
ŽIVKOVIĆ D, GABRIĆ I, ŠITIĆ S. Repair Welding of Titanium Alloy Construction. Strojarstvo [Internet]. 2011 [pristupljeno 09.06.2023.];53(4):319-319. Dostupno na: https://hrcak.srce.hr/80457
D. ŽIVKOVIĆ, I. GABRIĆ i S. ŠITIĆ, "Repair Welding of Titanium Alloy Construction", Strojarstvo, vol.53, br. 4, str. 319-319, 2011. [Online]. Dostupno na: https://hrcak.srce.hr/80457. [Citirano: 09.06.2023.]
Problems of welding titanium and titanium alloys, without the usage of special vacuum or inert atmosphere chambers, is expressed in welding repairs where parts may be different sizes and shapes. It would be too expensive to construct a protective atmosphere chamber for each individual case. Chambers usually are awkward for welders and also limit the process control. The purpose of this work is to find out the possibilities for performing quality repairs without the use of the special chamber. The practical part of our work deals with repair welding of clincker furnace camera case in a cement factory. The extreme working conditions lead to intensive wear of the camera case. Depending on the location in the clinker furance it needs to be changed or repaired after 6-12 months of exploitation. Repair is done by TIG welding process using dual secondary weld protection (face and root) with argon. The microstructure of the samples was analysed, and also hardness tests were done on the base material, heat affected zone and the weld. The study showed no significant changes in the microstructure of welds in relation to the base material, and the results of hardness tests were fairly uniform. After acceptable testing results the repair of camera case was done. The repaired camera case had the same expaltation life as the new case. This indicates that the repairs were carried out successfully.
Repair welding, Titan alloy, Welding technology, Weld testing
Posjeta: 1.662 *