Izvorni znanstveni članak

Influence of cutting parameters on heat-affected zone after laser cutting

Jana Petru orcid.org/0000-0002-2378-5678 ; VŠB-TUO, Faculty of Mechanical Engineering, Department of Machining and Assembly, 17. listopadu 15/2172, 708 33 Ostrava Poruba, Czech Republic
Tomas Zlamal ; VŠB-TUO, Faculty of Mechanical Engineering, Department of Machining and Assembly, 17. listopadu 15/2172, 708 33 Ostrava Poruba, Czech Republic
Robert Cep orcid.org/0000-0001-9610-4215 ; VŠB-TUO, Faculty of Mechanical Engineering, Department of Machining and Assembly, 17. listopadu 15/2172, 708 33 Ostrava Poruba, Czech Republic
Katarina Monkova orcid.org/0000-0002-5153-346X ; Faculty of Manufacturing Technologies of Technical University in Kosice with seat in Prešov, Bayerova 1, 080 01 Prešov, Slovakia
Peter Monka orcid.org/0000-0002-0963-5235 ; Faculty of Manufacturing Technologies of Technical University in Kosice with seat in Prešov, Bayerova 1, 080 01 Prešov, Slovakia

Sažetak

The article deals with a method of thermal cutting of materials, specifically with laser technology. The theoretical part describes its principles, capabilities and use of laser in the process of machining, mainly the procedure of cutting material using a laser beam. The experimental part is focused on cutting the cobalt alloy by a continuous CO2 laser and the influence of technological parameters during cutting on the final quality of the cutting area. Suitable technological parameters were determined on the basis of metallographic analysis, and the lowest heat influence on the material was achieved.

Ključne riječi

heat-affected zone (HAZ); laser cutting; laser parameter; machining

Hrčak ID:

100156

URI

https://hrcak.srce.hr/100156

Datum izdavanja:

15.4.2013.

Podaci na drugim jezicima: hrvatski

Posjeta: 5.119 *