Skoči na glavni sadržaj

Prethodno priopćenje

The influence of spin casting parameters on dimensional accuracy of castings cast into silicon moulds

Jan Vrabec ; Slovak University of Technology, Faculty of Materials Science and Technology, Paulínska 16, 917 24 Trnava, Slovak Republic
Martin Bajčičák ; Slovak University of Technology, Faculty of Materials Science and Technology, Paulínska 16, 917 24 Trnava, Slovak Republic
Matej Beznák ; Slovak University of Technology, Faculty of Materials Science and Technology, Paulínska 16, 917 24 Trnava, Slovak Republic
Roland Šuba ; Slovak University of Technology, Faculty of Materials Science and Technology, Paulínska 16, 917 24 Trnava, Slovak Republic


Puni tekst: hrvatski pdf 1.720 Kb

str. 519-524

preuzimanja: 262

citiraj

Puni tekst: engleski pdf 1.720 Kb

str. 519-524

preuzimanja: 388

citiraj


Sažetak

Spin casting is the technological process to produce metal, plastic and wax parts quickly from an existing master model. It is especially suitable for the manufacture of die casting parts since the manufacture of dies is normally very time-consuming and expensive. The paper deals with the influence of mould rotation speed and clamping pressure during spin casting into silicon moulds on dimensional accuracy of zinc alloy castings. The rotation speed was in range 200 ÷ 600 rpm. Clamping pressure was in range from 276 to 379,5 kPa. The results of experiments are curves of rotation speed and clamping pressure dependence on dimensional accuracy of castings.

Ključne riječi

centrifugal casting, mould, rotation speed, silicon

Hrčak ID:

104080

URI

https://hrcak.srce.hr/104080

Podaci na drugim jezicima: hrvatski

Posjeta: 1.105 *