Tehnički vjesnik, Vol. 20 No. 4, 2013.
Prethodno priopćenje
Effect of machining parameters on jet lagging in abrasive water jet cutting
Vlatko Marušić
; J. J. Strossmayer University of Osijek, Mechanical Engineering Faculty in Slavonski Brod, Trg Ivane Brlić-Mažuranić 2, 35000 Slavonski Brod, Croatia
Jelena Baralić
; Faculty of Technical Sciences Čačak, University of Kragujevac, Svetog Save St. 65, 32000 Čačak, Serbia
Bogdan Nedić
orcid.org/0000-0002-4236-3833
; Faculty of Engineering in Kragujevac, University of Kragujevac, Sestre Janjic Str. 6, 34000 Kragujevac, Serbia
Željko Rosandić
; J. J. Strossmayer University of Osijek, Mechanical Engineering Faculty in Slavonski Brod, Trg Ivane Brlić-Mažuranić 2, 35000 Slavonski Brod, Croatia
Sažetak
The main characteristics of the surface machined with the abrasive water jet are the differences in surface roughness at the top and bottom of the cut and the appearance of curved lines-striations, which are characteristic for all machining processes with the concentrated stream of high energy. The curvature of these lines is the consequence of jet lagging. Jet lagging is the cause of errors in cutting of radius and sharp corners. The machining parameters have a great influence on this phenomenon. Therefore, it is necessary to know and to define the influence of machining parameters on this phenomenon. The aim of this paper is to investigate the effect of machining parameters on the jet lagging, i.e. cut front geometry. The specimens of AISI 304 were machined by the abrasive water jet under varying traverse speeds, operating pressures and abrasive mass flow rates. The jet lagging was measured at ten monitoring points by the depth of cut. Based on these results, the relationship between the jet lagging and machining parameters has been formed.
Ključne riječi
abrasive water jet; jet lagging; machining parameters
Hrčak ID:
106700
URI
Datum izdavanja:
21.8.2013.
Posjeta: 1.974 *