Skoči na glavni sadržaj

Izvorni znanstveni članak

Experimental investigation of high speed milling of aluminium alloy

Julia Hricova ; Faculty of Environmental and Manufacturing Technology, Technical University in Zvolen, Studentska 26, 96053 Zvolen, Slovakia
Martin Kovac ; Faculty of Material Science and Technology in Trnava, Slovak University of Technology in Bratislava, Bottova 25, 917 24 Trnava, Slovakia
Peter Sugar orcid id orcid.org/0000-0002-9499-5672 ; Faculty of Material Science and Technology in Trnava, Slovak University of Technology in Bratislava, Bottova 25, 917 24 Trnava, Slovakia


Puni tekst: engleski pdf 1.069 Kb

str. 773-777

preuzimanja: 685

citiraj

Puni tekst: hrvatski pdf 1.069 Kb

str. 773-777

preuzimanja: 1.523

citiraj


Sažetak

The customer´s growing demand for higher quality products has forced manufacturing industry to continuously progress in quality control and machining technologies. One of the fundamental metal cutting processes is milling. The aim of this study is to investigate optimum cutting parameters of AlMgSi alloy (EN-AW 6060), which is one of the most commonly used aluminium alloys, using uncoated cemented carbide end mills. The influence of tool geometry (helix angle) and cutting conditions (cutting velocity, and feed rate) on the surface finish produced during high speed milling of aluminium alloy have been investigated. The significance of the parameters on surface roughness has been established with analysis of variance (ANOVA). The cutting parameters regarding surface roughness performance indexes are analysed, and the findings are discussed and evaluated.

Ključne riječi

aluminium alloy; end mill; high speed milling; surface roughness

Hrčak ID:

126072

URI

https://hrcak.srce.hr/126072

Datum izdavanja:

15.8.2014.

Podaci na drugim jezicima: hrvatski

Posjeta: 3.594 *