Izvorni znanstveni članak

PITTING OF TOOTH FLANKS OF CROSSED HELICAL GEARS MADE OF SINTERED STEEL

Đorđe Miltenović ; College of Textile, Leskovac, Serbia
Milan Tica ; Faculty of Mechanical Engineering, University of Banja Luka, Bosnia and Herzegovina
Aleksandar Miltenović orcid.org/0000-0002-1453-2548 ; Faculty of Mechanical Engineering, University of Niš, Serbia
Milan Banić ; Faculty of Mechanical Engineering, University of Niš, Serbia
Srđan Živković ; Faculty of Civil Engineering, University of Niš, Serbia
Žarko Mišković ; Faculty of Mechanical Engineering, University of Belgrade, Serbia

Sažetak

Crossed helical gears are used in cars and in many household appliances. The trend towards increased comfort in motor vehicles has led to the utilisation of more than a hundred servo-drives in luxury class automobiles. Important advantages of crossed helical gears are their easy and inexpensive design, low noise performance and high gear ratio that can be realised in one step. Sintered steel is a material with very favourable properties for the manufacture of crossed helical gears. High demands are set on gears made from sintered steel regarding wear and pitting load capacity. This report shows the results of the investigation into pitting resistance of crossed helical gears made of iron-based sintered material Fe1.5Cr0.2Mo that has undergone additional treatment.

Ključne riječi

sintered steel; gears; transmission; pitting

Hrčak ID:

135879

URI

https://hrcak.srce.hr/135879

Datum izdavanja:

4.3.2015.

Posjeta: 1.358 *