Skoči na glavni sadržaj

Izvorni znanstveni članak

Tailoring the gradient ultrafine-grained structure in low-carbon steel during drawing with shear

G. I. Raab ; Ufa State Aviation Technical University, Ufa
L. A. Simonova ; Kazan Federal University, Kazan, Russia
G. N. Alyoshin ; Ufa State Aviation Technical University, Ufa


Puni tekst: engleski pdf 194 Kb

str. 177-180

preuzimanja: 677

citiraj


Sažetak

Conventional drawing and drawing with shear were conducted on the rods of low-carbon steel. Deformation by simple drawing forms basically a homogenous structure and leads to a uniform change in microhardness along the billet volume. A comparative analysis of the models of these processes showed that shear drawing of steel at room temperature reduces energy characteristics in half, normal forces on the die – by 1,8, and enhances the strain intensity from 0,5 to 1,6. During drawing with shear, strain-induced cementite dissolution occurs and a gradient structure is formed, which increases the microhardness of the surface layer up to values close to 7 000 MPa.

Ključne riječi

low-carbon steel; drawing with shear; gradient structure; severe plastic deformation

Hrčak ID:

146490

URI

https://hrcak.srce.hr/146490

Datum izdavanja:

1.4.2016.

Posjeta: 1.146 *