Tehnički vjesnik, Vol. 23 No. 6, 2016.
Izvorni znanstveni članak
https://doi.org/10.17559/TV-20161020210442
Modelling of abrasive wear of Ni-based self-fluxing alloy coatings by the application of experimental design
Sara Havrlisan
; J. J. Strossmayer University of Osijek, Mechanical Engineering Faculty in Slavonski Brod, Trg I. Brlić-Mažuranić 2, 35000 Slavonski Brod, Republic of Croatia
Katica Simunovic
; J. J. Strossmayer University of Osijek, Mechanical Engineering Faculty in Slavonski Brod, Trg I. Brlić-Mažuranić 2, 35000 Slavonski Brod, Republic of Croatia
Djordje Vukelic
orcid.org/0000-0003-2420-6778
; University of Novi Sad, Faculty of Technical Sciences, Trg Dositeja Obradovića 6, 21000 Novi Sad, Republic of Serbia
Sažetak
In this paper resistance to abrasive wear is studied of the Ni-based self-fluxing alloy coatings deposited by flame spraying with fusion. The "dry sand/rubber wheel" test in accordance with the ASTM G65 norm, specifically B and C procedures is used. The experimental data are statistically processed by using analysis of variance, to investigate the influence of two input variables (type of coating: NiCrBSi, NiBSi; spraying distance: smaller, greater) and their interaction on the output variable (volume loss). Data for investigation were obtained by the full factorial design with two, previously mentioned, factors at two levels with three replications. The analysis of variance of obtained experimental data after 100 revolutions of wheel has shown that type of coating, spraying distance as well as interaction between these factors are significant and affect abrasive wear. At 2000 revolutions of wheel it has been found that the type of coating is a significant factor while the spraying distance, the same as interaction between these factors, is of no significance to abrasive wear.
Ključne riječi
abrasive wear; analysis of variance; experimental design; flame spraying with fusion; NiBSi; NiCrBSi
Hrčak ID:
169529
URI
Datum izdavanja:
29.11.2016.
Posjeta: 2.522 *