Izvorni znanstveni članak

https://doi.org/10.21278/TOF.41103

Determination of Stresses in the Axle Pin Based on the Wind Model in the Wind Turbine

Miljenko Cvetić orcid.org/0000-0003-1355-2499 ; Končar GIM, Zagreb. Croatia
Nenad Gubeljak orcid.org/0000-0002-3276-8431 ; University of Maribor, Faculty of Mechanical Engineering, Maribor, Slovenia

Sažetak

Even when all the details are provided, the design of wind turbines is a big challenge. The detailed knowledge of the deformation of vital wind turbine components caused by a wind with extreme operating gusts and other type of winds can be obtained only by performing measurements on the wind turbine. The vital component of the wind turbine is axle pin. This article presents the results of the measured changes in wind speed at the height at which strains were measured. The measured strains are used for calculating the stress. It is also shown that on the basis of the calculations on the wind model obtained with the GH Bladed software, the input data are obtained for the SolidWorks software, by which stress on the axle pin can be calculated. The final confirmation of the proper approach and the calculation is achieved by comparison between the calculated and the measured strains on the axle pin during exploitation of a wind turbine of nominal power output of 1 MW.

Ključne riječi

wind turbine; axle pin; principal stresses; measuring rosette

Hrčak ID:

179257

URI

https://hrcak.srce.hr/179257

Datum izdavanja:

26.4.2017.

Posjeta: 1.737 *