Izvorni znanstveni članak

https://doi.org/10.17559/TV-20131221170237

The effect of feed rate on durability and wear of exchangeable cutting inserts during cutting Ni-625

Jana Petrů ; VŠB - Technical University of Ostrava, 17. listopadu 15/2172, 708 33 Ostrava - Poruba, Czech Republic
Tomáš Zlámal ; VŠB - Technical University of Ostrava, 17. listopadu 15/2172, 708 33 Ostrava - Poruba, Czech Republic
Robert Čep orcid.org/0000-0001-9610-4215 ; VŠB - Technical University of Ostrava, 17. listopadu 15/2172, 708 33 Ostrava - Poruba, Czech Republic
Marek Sadílek orcid.org/0000-0001-6680-6865 ; VŠB - Technical University of Ostrava, 17. listopadu 15/2172, 708 33 Ostrava - Poruba, Czech Republic
Dana Stančeková ; Faculty of Mechanical Engineering of University of Zilina, Department of Machining and Manufacturing Technology, Univerzitna 1, 010 26 Zilina, Slovak Republic

Sažetak

This paper deals with the process of cutting of nickel superalloy and selection of suitable cutting parameters for its easy and effective cutting. The experimental part proposes three exchangeable inserts and determines the effect of feed rate cutting parameter during machining on durability and wear of the cutting tool. Depending on selected cutting feed rate and the amount of wear of these exchangeable cutting inserts, the quality of turned surface is evaluated and height roughness parameters are determined. In closing we show our observations obtained while machining Inconel 625, determine the effect of feed rate on durability and wear of cutting inserts, evaluate and recommend practical steps, describe the mechanisms of cutting wedge wear, determine the durability of the tool and roughness of the turned surface.

Ključne riječi

cutting; durability; exchangeable cutting inserts; flank wear; nickel superalloy

Hrčak ID:

181234

URI

https://hrcak.srce.hr/181234

Datum izdavanja:

10.5.2017.

Podaci na drugim jezicima: hrvatski

Posjeta: 2.786 *