Izvorni znanstveni članak
https://doi.org/10.15255/CABEQ.2017.1098
Catalytic Oxidation of Toluene on Hydrothermally Prepared Ceria Nanocrystals
M. Duplančić
; University of Zagreb, Faculty of Chemical Engineering and Technology, Marulićev trg 19, Zagreb, Croatia
S. Kurajica
; University of Zagreb, Faculty of Chemical Engineering and Technology, Marulićev trg 19, Zagreb, Croatia
V. Tomašić
; University of Zagreb, Faculty of Chemical Engineering and Technology, Marulićev trg 19, Zagreb, Croatia
I. Minga
; University of Zagreb, Faculty of Chemical Engineering and Technology, Marulićev trg 19, Zagreb, Croatia
Sažetak
Ceria nanocrystals were prepared hydrothermally and tested as potential catalysts for oxidation of volatile organic compounds using toluene as a model compound. Pure ceria with a crystallite size of 4 nm, determined by the Scherrer method from XRD pattern has been obtained. The specific surface area of the prepared nanoparticles determined by BET analysis yielded 201 m2 g–1, while the band gap of 3.2 eV was estimated from DRS spectrum via Tauc’s plot. Catalytic tests were performed on calcined ceria (500 °C) with increased crystallite size (9 nm) caused by thermal treatment. The tests
showed good activities for the toluene oxidation with T50 temperatures, corresponding to 50 % toluene conversion, observed at 250 °C and even lower temperatures depending on the total flow rate of the gas mixture. The one-dimensional pseudo-homogeneous model
of the fixed bed reactor was proposed to describe the reactor performance and the appropriate kinetic parameters were estimated. Good agreement between experimental data and the proposed model was observed.
This work is licensed under a Creative Commons Attribution 4.0 International License.
Ključne riječi
ceria; catalytic oxidation; nanomaterials; toluene; modelling
Hrčak ID:
192259
URI
Datum izdavanja:
10.1.2018.
Posjeta: 1.545 *