Prethodno priopćenje

https://doi.org/10.17559/TV-20170216095042

Analysis of Zones Created with Waterjet Cutting of AISI 316 L Corrosion Resistant Steel

Miroslav Duspara orcid.org/0000-0003-4249-9279 ; Faculty of Mechanical Engineering, J. J. Strossmayera University of Osijek, Trg Ivane Brlić Mažuranić 2, 35 000 Slavonski Brod, Croatia
Valnea Starčević ; Faculty of Mechanical Engineering, J. J. Strossmayera University of Osijek, Trg Ivane Brlić Mažuranić 2, 35 000 Slavonski Brod, Croatia
Ivan Samardžić ; Faculty of Mechanical Engineering, J. J. Strossmayera University of Osijek, Trg Ivane Brlić Mažuranić 2, 35 000 Slavonski Brod, Croatia

Sažetak

This work deals with the quality of machined surface obtained with waterjet cutting (WJC) technology, regarding the influence of selected dynamic parameters (traverse speed, abrasive mass flow rate and pressure) on the quality of machined surface. Examination presented in the work was carried out on specimens made from AISI 316L corrosion resistant steel and measured with portable surface roughness tester. Results obtained by experiment were analyzed with licensed version of software for statistical analysis Design Expert 10.

Ključne riječi

analysis of variance; central composite design; cutting parameters; surface quality; waterjet cutting

Hrčak ID:

199165

URI

https://hrcak.srce.hr/199165

Datum izdavanja:

21.4.2018.

Posjeta: 1.664 *