Izvorni znanstveni članak

https://doi.org/10.17559/TV-20170515084609

Implementation of Inductive Proximity Sensors in Active Magnetic Bearings

Miroslav Puskaric ; University of Rijeka, Center for Advanced Computing and Modelling, Radmile Matejcic 2, 51000 Rijeka, Croatia
Neven Bulic orcid.org/0000-0001-8957-020X ; University of Rijeka, Faculty of Engineering, Department of Automation and Electronics, Vukovarska 58, 51000 Rijeka, Croatia
Zlatan Car orcid.org/0000-0003-2817-9252 ; University of Rijeka, Faculty of Engineering, Department of Automation and Electronics, Vukovarska 58, 51000 Rijeka, Croatia

Sažetak

Research on the implementation of inductive proximity sensors in active magnetic bearings is performed in this paper. LDC1000 digital sensors manufactured by Texas Instruments are used since they claim to provide precision measured in microns and simple acquisition of the output data. The Sensor chip is connected with the sensing coil which is placed inside the magnetic bearing, close to electromagnets. This newly developed system created a platform for research in signal quality and its resistance to electrical noise. The controller used in this application was Texas Instruments TMS320F28335 digital signal processor (DSP). Software for data acquisition from LDC1000 was written and implemented in DSP using Code Composer Studio development environment. Two different output data are acquired and processed: proximity data and frequency count. Graphs presented in this paper show different resistance to electrical noise. A conclusion derived from this research can be applied in an industry where electromagnetic noise exists, together with the need for precise distance measurement.

Ključne riječi

electromagnetic noise; inductive sensor; magnetic bearing; proximity measurement

Hrčak ID:

212816

URI

https://hrcak.srce.hr/212816

Datum izdavanja:

16.12.2018.

Posjeta: 1.923 *