Skoči na glavni sadržaj

Izvorni znanstveni članak

https://doi.org/10.15644/asc53/2/4

Mechanical Properties of High Viscosity Glass Ionomer and Glass Hybrid Restorative Materials

Ivan Šalinović ; Studenti 6. godine Stomatološkog fakulteta Sveučilišta u Zagrebu, Zagreb, Hrvatska
Matea Stunja ; Studenti 6. godine Stomatološkog fakulteta Sveučilišta u Zagrebu, Zagreb, Hrvatska
Zdravko Schauper ; Zavod za materijale Fakulteta strojarstva i brodogradnje Sveučilišta u Zagrebu, Zagreb, Hrvatska
Željko Verzak ; Department of Pedodontics, School of Dental Medicine, University of Zagreb, Zagreb, Croatia
Ana Ivanišević Malčić ; Zavod za endodonciju i restaurativnu stomatologiju Stomatološkog fakulteta Sveučilišta u Zagrebu, Zagreb, Hrvatska
Valentina Brzović Rajić ; Zavod za endodonciju i restaurativnu stomatologiju Stomatološkog fakulteta Sveučilišta u Zagrebu, Zagreb, Hrvatska


Puni tekst: engleski pdf 312 Kb

str. 125-131

preuzimanja: 1.433

citiraj

Puni tekst: hrvatski pdf 312 Kb

str. 125-131

preuzimanja: 349

citiraj


Sažetak

Objectives: to determine the mechanical properties of hybrid and high-viscosity glass ionomer cements. Compressive strength and hardness of three glass ionomer cements (GIC) were measured: Ketac ™ Universal Aplicap ™, EQUIA Fil® and EQUIA FORTE Fil®, and the SEM sample analysis were performed. Material and Methods: The samples for measuring the compressive strength were prepared using silicone molds with standard dimensions of 6 mm x 4 mm and stored in deionized water for five days, while the samples for hardness measurement were prepared using Teflon molds with a cylindrical opening in the middle, dimensions 2 mm in height and 5 mm in width. For each material, one sample was made (n = 1) and stored in deionized water at 37ºC for 25 days. A representative sample of each material was analyzed using SEM. For the comparison of obtained values, the ANOVA test was used, while Tukey test was used for the multiple comparison. Results: There were no significant differences between the compressive strength of the three tested materials (p <0.05). The hardness values were: 157 HV0,2 for Ketac ™ Universal Aplicap ™ , 47 HV0,2 for EQUIA Fil® and 39 HV0,2 for EQUIA FORTE Fil®, respectively, and were significantly different, implying that Ketac ™ Universal Aplicap ™ has much higher hardness values than the other materials tested. SEM sample analysis
revealed similar fracture modes of the tested materials. Conclusion: It was concluded that there were no statistically significant differences in compressive strength and fracture modes between the tested materials, while Ketac ™ Universal Aplicap ™ hardness results were significantly higher than the ones measured for EQUIA Fil® and EQUIA FORTE Fil®.

Ključne riječi

Glass Ionomer Cement, Compressive Strength, Hardness, SEM.

Hrčak ID:

220898

URI

https://hrcak.srce.hr/220898

Podaci na drugim jezicima: hrvatski

Posjeta: 2.708 *