Skoči na glavni sadržaj

Transactions of FAMENA, Vol. 44 No. 2, 2020.

Izvorni znanstveni članak

https://doi.org/10.21278/TOF.44207

Effect of Elevated Temperatures on Mechanical Properties of Ultra High Strength Hot Work Tool Steel H11

Dušan Arsić orcid id orcid.org/0000-0003-0326-0898 ; Faculty of Engineering, University of Kragujevac, Kragujevac, Serbia
Vukić Lazić ; Faculty of Engineering, University of Kragujevac, Kragujevac, Serbia
Aleksandar Sedmak orcid id orcid.org/0000-0002-5438-1895 ; Faculty of Mechanical Engineering, University of Belgrade, Belgrade, Serbia
Srbislav Aleksandrović orcid id orcid.org/0000-0001-5068-5560 ; Faculty of Engineering, University of Kragujevac, Kragujevac, Serbia
Jelena Živković ; Faculty of Engineering, University of Kragujevac, Kragujevac, Serbia
Milan Djordjević orcid id orcid.org/0000-0001-7317-8334 ; Faculty of Technical Sciences, University of Priština, Kosovska Mitrovica, Serbia
Goran Mladenović ; Faculty of Mechanical Engineering, University of Belgrade, Belgrade, Serbia

Puni tekst: engleski pdf 3.032 Kb

str. 71-82

preuzimanja: 1.011

citiraj

Sažetak

This paper presents an experimental and numerical study into the influence of elevated temperatures on mechanical properties of the heat treated high quality hot work tool steel H11. This steel belongs to a group of alloyed steels with extraordinary mechanical properties. The aim of this study was to determine the highest temperature at which these properties are still maintained. The experimental investigation focused on the tensile testing of specimens at seven different temperatures, including the room temperature. The highest testing temperature was 700 °C. The heat treatment of plates (specimens) consisted of quenching and tempering. Although the strain hardening of this type of materials is small, the strain hardening curves were calculated to show if there was a possibility for the material to increase its strength due to exploitation loads. Also, a numerical analysis of the tensile test by using the finite element method was done in order to define an appropriate model for numerical testing. The obtained results are then compared with the experimental results.

Ključne riječi

H11 steel; elevated temperatures; tensile test; strain hardening; FEM

Hrčak ID:

238216

URI

https://hrcak.srce.hr/238216

Datum izdavanja:

18.6.2020.

Posjeta: 2.239 *