Skoči na glavni sadržaj

Prethodno priopćenje

Proposal of a new solution for mold temperature monitoring

J. Dobransky ; Faculty of Manufacturing Technologies with a seat in Prešov, Technical University of Košice, Slovak Republic
M. Pollak orcid id orcid.org/0000-0002-3794-3745 ; Faculty of Manufacturing Technologies with a seat in Prešov, Technical University of Košice, Slovak Republic
M. Kočiško orcid id orcid.org/0000-0002-0935-4871 ; Faculty of Manufacturing Technologies with a seat in Prešov, Technical University of Košice, Slovak Republic


Puni tekst: engleski pdf 2.554 Kb

str. 93-96

preuzimanja: 493

citiraj


Sažetak

The paper deals with the proposal of a new solution for monitoring the mold temperature. The mold is used for the production of thermosetting products by pressing technology. At present, the mold temperature is measured separately at sixteen locations of the mold. This measurement is lengthy and laborious, causing production downtime. At the same time, measurement is physically problematic since the mold has a temperature in the range of 130 to 150°C. The controller must manually record all measured data in the record and re-write the record to the computer. The new solution is to measure four control points at once. The controller will measure these points and the measured data will be sent online to the system. This method will clearly speed up the measurement process.

Ključne riječi

steel; mold; temperature; measurement; process

Hrčak ID:

246098

URI

https://hrcak.srce.hr/246098

Datum izdavanja:

4.1.2021.

Posjeta: 1.181 *