Skoči na glavni sadržaj

Tehnički vjesnik, Vol. 27 No. 6, 2020.

Izvorni znanstveni članak

https://doi.org/10.17559/TV-20180509152814

Optimal Design and Control of Multi-Motor Drive System for Industrial Application

Vojkan Kostić* orcid id orcid.org/0000-0002-7714-469X ; University of Niš, Faculty of Electronic Engineering, Serbia, 18000 Niš, Aleksandra Medvedeva 14
Nebojša Mitrović orcid id orcid.org/0000-0003-3767-3244 ; University of Niš, Faculty of Electronic Engineering, Serbia, 18000 Niš, Aleksandra Medvedeva 14
Bojan Banković orcid id orcid.org/0000-0002-5504-599X ; University of Niš, Faculty of Electronic Engineering, Serbia, 18000 Niš, Aleksandra Medvedeva 14
Filip Filipović orcid id orcid.org/0000-0002-1930-9273 ; University of Niš, Faculty of Electronic Engineering, Serbia, 18000 Niš, Aleksandra Medvedeva 14
Milutin Petronijević orcid id orcid.org/0000-0003-2396-0891 ; University of Niš, Faculty of Electronic Engineering, Serbia, 18000 Niš, Aleksandra Medvedeva 14

Puni tekst: engleski pdf 3.914 Kb

str. 1815-1824

preuzimanja: 1.120

citiraj

Sažetak

In this paper, the topology of the adjustable speed drive with active front end rectifier is considered in terms of application in multi-motor drives. A dynamic model of the rectifier with a coupled LCL filter is presented. A simulation model has been developed for the analysis of multi-motor drive system dynamics and power flow. Based on the simulation model, the functional possibilities of reversible induction motor drive with active front end converter and multiple voltage source inverters on a common DC bus at the motor side are analysed. One example of the application of a complex full regenerative multi-motor drive system on a common DC bus for an industrial crane, implemented with Siemens converters, is shown. The motor and generator mode of operation from the aspect of energy saving as well as the influence of drives on the distribution network from the aspect of higher harmonics and power factors are analysed. Siemens's original software, Starter commissioning tool, for drives configuration and data acquisition is used.

Ključne riječi

Active Front End; common DC bus; multi-motor drive system

Hrčak ID:

248215

URI

https://hrcak.srce.hr/248215

Datum izdavanja:

19.12.2020.

Posjeta: 2.244 *