Skoči na glavni sadržaj

Stručni rad

Optimization of protecting wall tool for manufacture and assembly

Ivica Stanić ; Mechanical Engineering Faculty in Slavonski Brod, University in Osijek, Slavonski Brod, Croatia
Tomislav Galeta orcid id orcid.org/0000-0002-0770-5447 ; Mechanical Engineering Faculty in Slavonski Brod, University in Osijek, Slavonski Brod, Croatia
Mirko Karakašić ; Mechanical Engineering Faculty in Slavonski Brod, University in Osijek, Slavonski Brod, Croatia


Puni tekst: engleski pdf 1.509 Kb

str. 45-49

preuzimanja: 793

citiraj


Sažetak

Many tools for metal forming manufacturing are made by copying similar tools with only minimum adaptation regarding the new product. Since such tools are not optimized for manufacture and assembly, it provides a variety of topics for bachelor theses for candidates at the mechanical engineering faculties. In this paper, the optimization of the metal forming tool for protecting wall regarding manufacture and assembly, performed in a bachelor thesis is presented. The optimization is based on approaches known as Design for Assembly and Design for Manufacture. The resulting tool model shows that there is enough space for improvement that can be done and that considered design approaches could be a source for several new interesting bachelor theses.

Ključne riječi

Design for Manufacture (DFM), Design for Assembly (DFA), Computer-Aided Design (CAD), Metal Forming

Hrčak ID:

23472

URI

https://hrcak.srce.hr/23472

Podaci na drugim jezicima: hrvatski

Posjeta: 1.428 *