Prethodno priopćenje

https://doi.org/10.17559/TV-20200206103034

Conventional Shaping the Edges of Thick Steel Plates After Welding Process

Waldemar Matysiak* orcid.org/0000-0002-2865-3973 ; Poznan University of Technology, 3 Piotrowo Street, 60-965 Poznan, Poland
Miroslav Duspara ; Mechanical engineering faculty in Slavonski Brod, University of Slavonski Brod, 35000 Slavonski Brod, Croatia
Josip Cumin ; Mechanical engineering faculty in Slavonski Brod, University of Slavonski Brod, 35000 Slavonski Brod, Croatia
Ivan Samardžić ; Mechanical engineering faculty in Slavonski Brod, University of Slavonski Brod, 35000 Slavonski Brod, Croatia

Sažetak

The paper presents the results of theoretical analysis and experimental details of shaping the edges of thick steel plate using conventional technology. The aim was to determine the influence of holes laser cutting on the shape and technological possibilities of the steel sheet edges flanging. In this study numerous computer simulations were made in order to design a process guaranteeing obtaining a proper product. During this simulation of material flow kinematics, strain and damage criterion distributions and shaping were analyzed. On the basis of the obtained results, the analysis of limiting phenomena, which could appear during the process, was made. Experimental tests in industrial conditions according to designed technology were carried out. Good quality of specimens shaping was obtained. It was found that shaping the edges of thick steel plate after welding process is possible.

Ključne riječi

conventional shaping; metal working; shaping thick steel plate; welding process

Hrčak ID:

255884

URI

https://hrcak.srce.hr/255884

Datum izdavanja:

17.4.2021.

Posjeta: 1.153 *