Izvorni znanstveni članak
https://doi.org/10.31534/engmod.2021.1.ri.05v
Non-linear Analysis of the Expanding Stage in the UOE Pipe Manufacturing Process
Mohammad Dagdughi
; Liberty Steel Hartlepool, SAW Pipe Mills, Brenda Road, Hartlepool, TS25 2EF, UNITED KINGDOM
Perk Lin Chong
; School of Computing, Engineering and Digital Technologies, Teesside University, Middlesbrough, TS1 3BX, UNITED KINGDOM
Justin Cox
; Liberty Steel Hartlepool, SAW Pipe Mills, Brenda Road, Hartlepool, TS25 2EF, UNITED KINGDOM
Sajid Abdullah
; School of Computing, Engineering and Digital Technologies, Teesside University, Middlesbrough, TS1 3BX, UNITED KINGDOM
Sažetak
In recent years, the increasing demand for energy has pushed oil and gas activities into more remote regions of the sea, which resulted in laying pipelines at depths greater than 2000m where they are vulnerable to collapse failure. Therefore, pipes are required to be manufactured with higher circularity and thicker wall thickness, this introduces a challenge for UOE pipe manufacturers as the process will involve the application of high forces in each forming step to form the plate into a pipe, and this could affect the integrity of equipment and tools such as the mechanical expander die segments. The aim of this paper is to investigate the expansion stage in the UOE pipe manufacturing process using Finite Element Analysis (FEA). Firstly, the stresses encountered by the pipe and mechanical expander dies during the expansion stage were analysed. The study revealed that the expansion stage causes the formation of wave patterns and concavities on the pipe surfaces which results in wall thickness variation. In addition, the study showed that the pipe ovality after the expansion is between (0.034%) and (0.055%). Furthermore, the study revealed that the Von-Mises stresses, the mechanical expander dies experience during the expansion are about (10.26%) lower than the pipe’s yield strength. Secondly, the FEA was carried out to investigate the benefit of optimising the mechanical expander dies design on the finished pipe shape. This study showed that reducing the expander die radius by (1%) significantly improves the pipe shape compared to the original expander die size and lowers the stress concentration on the expander dies.
Ključne riječi
UOE pipe; Large diameter pipe; Longitudinally welded large diameter pipes; Finite element analysis
Hrčak ID:
258820
URI
Datum izdavanja:
12.2.2021.
Posjeta: 1.471 *