Tehnički vjesnik, Vol. 28 No. 5, 2021.
Prethodno priopćenje
https://doi.org/10.17559/TV-20200731144524
Proposal of a Reference Object in Dimensional Measurements using Computed Tomography
Amalija Horvatić Novak*
; University of Zagreb, Faculty of Mechanical Engineering and Naval Architecture, Ivana Lučića 5, 10000 Zagreb, Croatia
Biserka Runje
; University of Zagreb, Faculty of Mechanical Engineering and Naval Architecture, Ivana Lučića 5, 10000 Zagreb, Croatia
Ivan Samardžić
; University of Slavonski Brod, Mechanical Engineering Faculty, Trg Ivane Brlić Mažuranić 2, 35000 Slavonski Brod, Croatia
Leon Maglić
; University of Slavonski Brod, Mechanical Engineering Faculty, Trg Ivane Brlić Mažuranić 2, 35000 Slavonski Brod, Croatia
Sažetak
Computed tomography is a non-destructive method that uses the nature of X-ray in order to measure both inner and outer objects' geometry. Because of many advantages and possibilities of conducting both material analysis inspection and dimensional measurement in a non-destructive way, the method is increasingly represented in industry. However, the method is very complex and has a huge number of influence parameters that cause errors in measurement results. Consequently, the measurement uncertainty as well as metrological traceability in general case are not achieved. In order to minimize and eliminate systematic errors, the reference objects are used. The usage of reference object for the purpose of identification and compensation of systematic errors is a generally accepted approach to ensure traceability. This article gives an overview of existing reference objects used in dimensional metrology with computed tomography and presents a new reference object.
Ključne riječi
computed tomography; dimensional measurement; metrological traceability; reference object; systematic error
Hrčak ID:
261352
URI
Datum izdavanja:
15.8.2021.
Posjeta: 1.155 *