Skoči na glavni sadržaj

Izvorni znanstveni članak

https://doi.org/10.31803//tg-20210629221349

Influence of the Polymer Plate Thickness on the Plate Distortion Factor in Flexography

Dean Valdec orcid id orcid.org/0000-0001-6897-8601 ; University North, Trg dr. Žarka Dolinara 1, 48000 Koprivnica, Croatia
Renata Tomerlin orcid id orcid.org/0000-0001-9713-7035 ; Podravka d.d. (plc), Ante Starčevića 32, 48000 Koprivnica, Croatia
Krunoslav Hajdek orcid id orcid.org/0000-0001-6572-5529 ; University North, Trg dr. Žarka Dolinara 1, 48000 Koprivnica, Croatia
Petar Miljković ; University North, Trg dr. Žarka Dolinara 1, 48000 Koprivnica, Croatia


Puni tekst: engleski pdf 1.286 Kb

str. 47-52

preuzimanja: 1.165

citiraj


Sažetak

Flexographic printing plate is used for the transfer of image onto a printing substrate. The surface of printing plate is stretched lengthwise when the plate is mounted on plate cylinder. As a result, the print length on the impression is always longer than the actual length of the plate. Prepress must compensate for this difference in length. The result of wrong plate distortion is different print length in flexography compared to the processes that follow printing. The aim of this paper is to research the influence of repeat length in printing and polymer plate thickness on the factor distortion. The distortion factor values were calculated using the derived formulas. Regardless of the repeat length in printing, the value of the thickness factor for a particular printing plate is constant. However, the values of the distortion factor decrease with the increasing thickness of the polymer plate and the decreasing of the total plate cylinder circumference.

Ključne riječi

factor distortion; flexography; polymer plate; print diameter; repeat length

Hrčak ID:

271928

URI

https://hrcak.srce.hr/271928

Datum izdavanja:

4.2.2022.

Posjeta: 2.002 *