Izvorni znanstveni članak

Effect of process parameters on forming quality of Mg alloy(MZ21)-Al alloy(7075) composite pipe

J. B. Zheng ; Ningbo University, School of Mechanical Engineering and Mechanics, Ningbo, China
X. D. Shu ; Ningbo University, School of Mechanical Engineering and Mechanics, Ningbo, China
S. Zhang
Q. Y. Lu

Sažetak

This paper mainly studies the effect of process parameters on the deformation mechanism of MZ21 magnesium alloy and 7075 aluminum alloy bimetal composite pipe in spinning process.The two parameters of spinning, the rotary wheel feed ratio and the double tube wall thinning rate were selected to study, and the influence rule of each process parameter on the forming quality of composite tube was simulated by Simufact software. Under different thinning rates of the total wall thickness, the coordinated deformation and the rebound law of the wall thickness of the composite pipe are obtained. The results provide a certain reference for the preparation of magnesium aluminum composite pipe and the selection of reasonable spinning parameters.

Ključne riječi

composite pipe; MZ21-7075; process parameters; forming quality; simulation

Hrčak ID:

273973

URI

https://hrcak.srce.hr/273973

Datum izdavanja:

1.7.2022.

Posjeta: 931 *