Tehnički vjesnik, Vol. 31 No. 6, 2024.
Izvorni znanstveni članak
https://doi.org/10.17559/TV-20240717001856
Analysis of Kerf Width and its Variation in CO2 Laser Cutting of Straight and Curved Cut Profiles
Miloš Madić
; University of Niš, Faculty of Mechanical Engineering in Niš, Aleksandra Medvedeva 14, 18000 Niš, Serbia
*
Constantin Cristinel Girdu
; Transilvania University of Brasov, Department of Manufacturing Engineering, Eroilor Street 29, 500036 Brasov, Romania
Dragan Marinković
; Institute of Mechanical Science, Vilnius Gediminas Technical University, 10105 Vilnius, Lithuania
Predrag Janković
; University of Niš, Faculty of Mechanical Engineering in Niš, Aleksandra Medvedeva 14, 18000 Niš, Serbia
Milan Trifunović
; University of Niš, Faculty of Mechanical Engineering in Niš, Aleksandra Medvedeva 14, 18000 Niš, Serbia
* Dopisni autor.
Sažetak
Geometrical characteristics of obtained kerf are important quality indicators in laser cutting. Considering that they are differently affected by a number of factors, this study is focused on the analysis of kerf width and its variation in CO2 laser cutting of straight and curved cut profiles. For the purpose of analysis and modeling of possible curvatures in considered outputs, a three-level full factorial design with replication was performed by considering severance energy and nitrogen pressure, which play a key role in the mechanisms of melting and ejection of molten material from the kerf. Based on experimental results multiple analysis were conducted including the analysis of the effects of severance energy and nitrogen pressure on kerf width and its variation on both straight and curved cut profiles. Further, by developing four prediction models and using overlay contour plots, simultaneous analyses of the kerf width and its variation were performed for both profiles and favourable cutting conditions were identified. The obtained results and observations made indicated favourable conditions for kerf width minimization and its variation, which, however, do not coincide for both cutting profiles.
Ključne riječi
316L stainless steel; CO2 laser cutting; curved cut profile; kerf width; kerf width variation; straight cut profile
Hrčak ID:
321909
URI
Datum izdavanja:
31.10.2024.
Posjeta: 153 *