Izvorni znanstveni članak

Chip Formation Analysis During Hard Turning

Robert ČEP ; Faculty of Mechanical Engineering, VSB - TU, Ostrava, Czech Republic
Miroslav NESLUŠAN ; Faculty of Mechanical Engineering, Zilina University,Zilina, Slovakia
Branimir BARIŠIĆ ; Tehnički fakultet Sveučilišta u Rijeci,Rijeka,Hrvatska

Sažetak

The paper deals with analysis of chip formation and related aspects of chip formation, like chip thickness, chip ratio, shear angle and chip segmentation during turning of hardened steel 100Cr6. The paper makes a comparison of some aspects of chip formation between turning annealed and hardened roll bearing steel 100Cr6. The results of the analysis show that there is formation of a segmented chip in the case of hard turning. This process of the chip formation significantly affects all parameters related to the plastic deformation in the cutting zone. Moreover, the formation of the segmented chip causes instability of a cutting process, the high intensity of tool wear and generation of significant heat in the cutting zone. The heat causes high temperature in the cutting zone (thermal load of a cutting tool).

Ključne riječi

Chip Formation; Hardened Steel; Plastic Deformation; Turning

Hrčak ID:

40652

URI

https://hrcak.srce.hr/40652

Datum izdavanja:

31.12.2008.

Posjeta: 1.981 *