Skoči na glavni sadržaj

Prethodno priopćenje

Design of experiment’s application in the optimization of milling process

D. Bajić ; Faculty of Electrical Engineering, Mechanical Engineering and Naval Architecture, University of Split, Split, Croatia
S. Jozić ; Faculty of Electrical Engineering, Mechanical Engineering and Naval Architecture, University of Split, Split, Croatia
S. Podrug ; Faculty of Electrical Engineering, Mechanical Engineering and Naval Architecture, University of Split, Split, Croatia


Puni tekst: engleski pdf 286 Kb

str. 123-126

preuzimanja: 1.614

citiraj


Sažetak

This paper examines the influence of cutting parameters on surface roughness of steel workpiece. The experiments have been carried out in accordance with a design of experiments (DOE). Equation for the surface roughness, as a function of cutting parameters, has been obtained by means of regression analysis. To obtain the minimal value of surface roughness, the equation optimizing was performed by using partial derivations and solving system of equations. The Taguchi method, with orthogonal arrays and signal to noise ratio, has been used to analyze impact of various cutting parameters on surface roughness and to find optimal levels of the cutting parameters. The comparison of results obtained by means of the response surface method and the Taguchi
method was performed.

Ključne riječi

face milling, surface roughness, design of experiments, regression analysis, Taguchi method

Hrčak ID:

43656

URI

https://hrcak.srce.hr/43656

Podaci na drugim jezicima: hrvatski

Posjeta: 2.084 *