Skip to the main content

Original scientific paper

Influence of cutting parameters on heat-affected zone after laser cutting

Jana Petru orcid id orcid.org/0000-0002-2378-5678 ; VŠB-TUO, Faculty of Mechanical Engineering, Department of Machining and Assembly, 17. listopadu 15/2172, 708 33 Ostrava Poruba, Czech Republic
Tomas Zlamal ; VŠB-TUO, Faculty of Mechanical Engineering, Department of Machining and Assembly, 17. listopadu 15/2172, 708 33 Ostrava Poruba, Czech Republic
Robert Cep orcid id orcid.org/0000-0001-9610-4215 ; VŠB-TUO, Faculty of Mechanical Engineering, Department of Machining and Assembly, 17. listopadu 15/2172, 708 33 Ostrava Poruba, Czech Republic
Katarina Monkova orcid id orcid.org/0000-0002-5153-346X ; Faculty of Manufacturing Technologies of Technical University in Kosice with seat in Prešov, Bayerova 1, 080 01 Prešov, Slovakia
Peter Monka orcid id orcid.org/0000-0002-0963-5235 ; Faculty of Manufacturing Technologies of Technical University in Kosice with seat in Prešov, Bayerova 1, 080 01 Prešov, Slovakia


Full text: croatian pdf 2.129 Kb

page 225-230

downloads: 595

cite

Full text: english pdf 2.129 Kb

page 225-230

downloads: 3.247

cite


Abstract

The article deals with a method of thermal cutting of materials, specifically with laser technology. The theoretical part describes its principles, capabilities and use of laser in the process of machining, mainly the procedure of cutting material using a laser beam. The experimental part is focused on cutting the cobalt alloy by a continuous CO2 laser and the influence of technological parameters during cutting on the final quality of the cutting area. Suitable technological parameters were determined on the basis of metallographic analysis, and the lowest heat influence on the material was achieved.

Keywords

heat-affected zone (HAZ); laser cutting; laser parameter; machining

Hrčak ID:

100156

URI

https://hrcak.srce.hr/100156

Publication date:

15.4.2013.

Article data in other languages: croatian

Visits: 5.119 *