Original scientific paper
Quantifying the Use of Brush Mats in Reducing Forwarder Peak Loads and Surface Contact Pressures
Eric R. Labelle
; Faculty of Forestry and Environmental Management University of New Brunswick PO Box 4400 Fredericton, New Brunswick, E3B 5A3 CANADA
Dirk Jaeger
; Institute of Forest Utilization and Work Science University of Freiburg GERMANY
Abstract
Forest biomass from timber harvesting residues is often used during mechanized forest operations to improve trafficability of strip roads (machine operating trails). In particular, during cut-to-length operations brush mats from harvesting residues are created on operating trails to reduce rutting. However, forest biomass is becoming increasingly important as a source of renewable energy. To maintain its full calorific value as a biofuel, brush (tree limbs, tops, and foliage) needs to be free of any mineral soil, which is considered a contaminant in this context. In cut-to-length operations, this eliminates any use of brush as a mat to improve trafficability on machine operating trails since it gets in direct contact with mineral soil. Using brush exclusively for biofuel will leave operating trails uncovered and can result in severe damage to forest soils. To manage the two competing uses of brush, it would be helpful to determine minimum brush amounts needed for efficient soil protection as it would potentially allow utilizing remaining brush as biofuel. This study assessed brush mats for their ability to distribute applied loads. As load distributing capacity of a brush mat increases, so does the resulting soil protecting effect. A total of 15 test scenarios were performed with a forwarder to analyze differences in peak loads recorded underneath brush mats of 5, 10, 15, 20, 25, and 30 kg m-2 (green mass) each subjected to 12 traffic cycles of a forwarder including unloaded and loaded movements. Highest loads were recorded within the first few forwarding cycles located on the 5 kg m–2 brush mat and then decreased on average by 23.5% as brush amount increased up to 30 kg m–2. When no brush was used (0 kg m–2) and the forwarder was in direct contact with the steel surface of the load test platform, we noticed that 97% of all peak surface contact pressures recorded exceeded the 150 kPa pressure threshold, compared to only 41% when the forwarder was driven over the 30 kg m–2 brush mat.
Keywords
biomass; brush mats; forest machinery; surface contact pressure; soil protection
Hrčak ID:
116844
URI
Publication date:
3.9.2012.
Visits: 1.860 *