Original scientific paper

https://doi.org/10.17559/TV-20160119134502

Analysis of the influence of cutting parameters on surface roughness in laser cutting of tungsten alloy using control charts

Derzija Begic-Hajdarevic ; University of Sarajevo, Mechanical Engineering Faculty, Vilsonovo setaliste 9, 71000 Sarajevo, Bosnia and Herzegovina
Branko Vucijak orcid.org/0000-0003-3572-8803 ; University of Sarajevo, Mechanical Engineering Faculty, Vilsonovo setaliste 9, 71000 Sarajevo, Bosnia and Herzegovina
Mugdim Pasic ; University of Sarajevo, Mechanical Engineering Faculty, Vilsonovo setaliste 9, 71000 Sarajevo, Bosnia and Herzegovina
Izet Bijelonja ; University of Sarajevo, Mechanical Engineering Faculty, Vilsonovo setaliste 9, 71000 Sarajevo, Bosnia and Herzegovina

Abstract

The paper presents analysis of the influence of cutting parameters on surface roughness during CO2 laser cutting process of tungsten alloy by using nitrogen as assist gas, based on control charts made by statistical process control (SPC) approach. Dependent variable is surface roughness, while independent variables are laser power and cutting speed. The control chart used within this paper is a variation of the moving means chart of experimental data samples, that calculates mean and range values using the three consecutive individual values. Applying the criteria often used in the SPC methods for the assessment of "out of control" situations, it may be inferred that increasing the cutting speed leads to worsening of control status for the process with lower laser power used.

Keywords

control charts; CO2 laser cutting; surface roughness; statistical process control; tungsten alloy

Hrčak ID:

186073

URI

https://hrcak.srce.hr/186073

Publication date:

2.9.2017.

Article data in other languages: croatian

Visits: 3.018 *