Original scientific paper

Influence of saw blade clearance over the workpiece on tool-wear

Mikuláš Siklienka ; Faculty of Wood Sciences and Technology, Technical University in Zvolen, Republic of Slovakia
Luboš Mišura ; Faculty of Wood Sciences and Technology, Technical University in Zvolen, Republic of Slovakia

Abstract

This paper presents the results of experimental measurement of tool-wear in the cutting process with circular saw of oak wood depending on the upper clearance of 5mmand 50 mm, respectively. The circular saw blade made of HSS by Pilana was used for the experiment. The measurement was carried out by the experimental equipment designed by the Department of Woodworking, Technical University of Zvolen and DMMA–36 circular saw made by Reszelski Zaklad Przemyslu Leoenictwa in Reszel. The tool-wear was evaluated by two parameters and namely by the radius of the cutting edge rn and by the cutting edge recession SV. The results of tool-wear are presented in dependence on the indicated chip length and cutting material length. With the change of the clearance from 5 mm to 50 mm and with the thickness of the test specimen h = 30 mm almost double
amount of sawn wood is required to attain the same chip length. The results have shown that in dependence on the length of the cutting material, the tool wear is smaller at a higher clearance of saw blade over the workpiece.

Keywords

circular saw; tool-wear; clearance; saw blade

Hrčak ID:

30543

URI

https://hrcak.srce.hr/30543

Publication date:

18.12.2008.

Article data in other languages: croatian

Visits: 2.239 *