Review article
In-mould decoration
Aida ŽGOMBIĆ-VICKOVIĆ
; Society of Plastics and Rubber Engineers, Zagreb
Tomislav PALAJSA
; Kaplast d.d., Vojnić
Igor ČATIĆ
orcid.org/0000-0002-1916-5898
; University of Zagreb, Faculty of Mechanical Engineering and Naval Architecture, Zagreb
Abstract
The appearance of injection moulded parts has been gaining more and more in importance. In-mould decoration can help to reach this goal. Some of in-mould decoration technologies are described. These are in-mould labelling, painting and lamination. The attention is called to some modern variants of injection moulding decoration: Decoform and Decopress. The examples of using in-mould labelling are given based on the introduction of this procedure in one Croatian company.
Keywords
in-mould decoration; in-mould labelling; in-mould lamination; in-mould painting
Hrčak ID:
47952
URI
Publication date:
5.2.2010.
Visits: 1.778 *