Original scientific paper

Study of changes under the machined surface and accompanying phenomena in the cutting zone during drilling of stainless steels with low carbon content

J. Jurko ; Faculty of Manufacturing Technologies, Tu Košice, Prešov, Slovakia
M. Gajdoš ; Faculty of Manufacturing Technologies, Tu Košice, Prešov, Slovakia
A. Panda ; Faculty of Manufacturing Technologies, Tu Košice, Prešov, Slovakia

Abstract

This article presents the results of experiments that concerned the verification of machined surface conditions of workpieces from a new austenitic stainless steel with Extra Low Carbon (ELC) Cr22Ni9MoTi compared with stainless steels Cr18Ni8. The results of cutting zone evaluation under cutting speed 80 m/min, depth of cut 2,75 mm and feed 0,08 mm per rev., a definition of shear level angle Φ1. For Cr22Ni9MoTi steel Φ₁ is 36° to 39°. The acquired results are interesting in that for the defined conditions we can achieve a quality outer surface after cutting with roughness parameters down to around 0,65 μm at cutting speed 80 m/min and feed 0.08 mm per rev.

Keywords

steel; surface; tool; drilling; cutting zone

Hrčak ID:

62729

URI

https://hrcak.srce.hr/62729

Publication date:

1.4.2011.

Article data in other languages: croatian

Visits: 1.412 *