Skoči na glavni sadržaj

Stručni rad

RETROFIT OF A ROLLER BRAKE TESTER AT FAMENA

Mladen Božić ; Faculty of Mechanical Engineering and Naval Architecture, University of Zagreb, Zagreb, Croatia
Ante Vučetić ; Faculty of Mechanical Engineering and Naval Architecture, University of Zagreb, Zagreb, Croatia
Petar Ilinčić ; Faculty of Mechanical Engineering and Naval Architecture, University of Zagreb, Zagreb, Croatia
Zoran Lulić ; Faculty of Mechanical Engineering and Naval Architecture, University of Zagreb, Zagreb, Croatia


Puni tekst: engleski pdf 2.367 Kb

str. 95-102

preuzimanja: 1.176

citiraj


Sažetak

The vehicle brake tester described in this paper is placed in the Laboratory for IC Engines and Motor Vehicles at the Faculty of Mechanical Engineering and Naval Architecture (FAMENA) in Zagreb. As the device, built in 1983, was inoperative, a decision was made for retrofit rather than repair. The retrofit included a reconstruction of some parts and modification of the braking force measurement. Adaptation of monitoring and control was made on electronic components that control the roller set during the manual and the automatic operation.
Using the LabVIEW programming software, our team created a computer program for monitoring the positioning of a vehicle on the device, the measuring of vehicle mass needed for the calculation of braking coefficient, the control of operating mode (automatic or manual) and the start/stop mode of electro motors inside the device.

Ključne riječi

vehicle; brake test; wheel force; LabVIEW

Hrčak ID:

129618

URI

https://hrcak.srce.hr/129618

Datum izdavanja:

19.11.2014.

Posjeta: 2.119 *

accessibility

closePristupačnostrefresh

Ako želite spremiti trajne postavke, kliknite Spremi, ako ne - vaše će se postavke poništiti kad zatvorite preglednik.