Izvorni znanstveni članak

Influence of traverse speed on surface irregularities created by the abrasive waterjet

J. Valíček ; Faculty of Manufacturing Technologies TU Košice with a seat in Prešov, Slovakia
S. Hloch ; Faculty of Manufacturing Technologies TU Košice with a seat in Prešov, Slovakia
I. Samardžić ; Mechanical Engineering Faculty J. J. Strossmayer University of Osijek,Slavonski Brod, Croatia
M. Kušnerová ; Faculty of Manufacturing Technologies TU Košice with a seat in Prešov, Slovakia
M. Zeleňák ; Faculty of Manufacturing Technologies TU Košice with a seat in Prešov, Slovakia

Sažetak

The paper deals with the calculation of the optimal traverse speed for diff erent types of materials, which is very important for predication, imaginings and dimensioning of technological factors and selection of the materials with the aim to increase of surface quality at abrasive waterjet cutting (AWJ) technology. The surface irregularities of the experimental used materials AISI 304, AISI 309 have been measured by non-contact shadow method. New empirically compiled equations of the infl uence of the traverse speed on tensometrical state of cut, deformation resistance of material and surface roughness Ra are at AWJ cutting available.

Ključne riječi

abrasive waterjet; surface quality; traverse speed; material

Hrčak ID:

71170

URI

https://hrcak.srce.hr/71170

Datum izdavanja:

2.1.2012.

Podaci na drugim jezicima: hrvatski

Posjeta: 2.263 *