Tehnički vjesnik, Vol. 21 No. 3, 2014.
Izvorni znanstveni članak
A high speed current dq PI controller for PMSM drive
Mohammad Marufuzzaman
; Faculty of Engineering and Built Environment, Department of Electrical, Electronic and Systems Engineering, Universiti Kebangsaan Malaysia, 43600 Bangi, Selangor, Malaysia
Mamun Bin Ibne Reaz
orcid.org/0000-0002-0459-0365
; Faculty of Engineering and Built Environment, Department of Electrical, Electronic and Systems Engineering, Universiti Kebangsaan Malaysia, 43600 Bangi, Selangor, Malaysia
Labonnah Farzana Rahman
; Faculty of Engineering and Built Environment, Department of Electrical, Electronic and Systems Engineering, Universiti Kebangsaan Malaysia, 43600 Bangi, Selangor, Malaysia
Tae Gyu Chang
; School of Electrical and Electronics Engineering, Chung-Ang University, 221, Heuksuk-dong, Dongjak-ku, Seoul 156-756, South Korea
Sažetak
A Field Programmable Gate Array (FPGA) based solution of current dq PI controller is proposed in this research, which is usually implemented in digital signal processor (DSP) based computer. The main problem in DSP based solution is the execution time, which is usually in microseconds range as well as reaching its physical limits. Therefore, completing the execution within nanoseconds becomes a major challenge to all researchers, which can be done by reducing the clock cycles. Implementing the overall controlling algorithm into FPGA will certainly reduce the execution time dramatically to pledge the steadiness of the motor. The result shows that the proposed FPGA performance requires only 68 ns of execution time for operating frequency of 30 MHz and accuracy of 99,9 %, which is the lowest computational cycle for the era.
Ključne riječi
current dq; FOC PMSM (Field Oriented Control of Permanent Magnet Synchronous Motor); FPGA (Field Programmable Gate Array); PI controller
Hrčak ID:
123309
URI
Datum izdavanja:
24.6.2014.
Posjeta: 4.348 *