Tehnički vjesnik, Vol. 23 No. 5, 2016.
Izvorni znanstveni članak
https://doi.org/10.17559/TV-20150520103655
Accuracy in the geometrical characteristics reduction method of step shaft at deflection computing
Stanislav Kotšmíd
; Faculty of Environmental and Manufacturing Technology, Technical University in Zvolen, Študentská 26, 960 01 Zvolen, Slovak Republic
Ján Marienčík
; Faculty of Environmental and Manufacturing Technology, Technical University in Zvolen, Študentská 26, 960 01 Zvolen, Slovak Republic
Pavel Beňo
orcid.org/0000-0002-6595-7757
; Faculty of Environmental and Manufacturing Technology, Technical University in Zvolen, Študentská 26, 960 01 Zvolen, Slovak Republic
Marian Minárik
; Faculty of Environmental and Manufacturing Technology, Technical University in Zvolen, Študentská 26, 960 01 Zvolen, Slovak Republic
Dražan Kozak
orcid.org/0000-0001-5245-4686
; Mechanical Engineering Faculty in Slavonski Brod, J. J. Strossmayer University of Osijek, Trg Ivane Brlic Mazuranic 2, HR-35000 Slavonski Brod, Croatia
Pejo Konjatić
orcid.org/0000-0002-1516-3027
; Mechanical Engineering Faculty in Slavonski Brod, J. J. Strossmayer University of Osijek, Trg Ivane Brlic Mazuranic 2, HR-35000 Slavonski Brod, Croatia
Sažetak
The paper deals with the computing method of step shaft deflection in an intended place by using the diameter reduction method. This method is analytically studied on the selected shaft shape at different variants of diameters and individual span lengths, where values of deflection are compared with computed values without using this reduction. These values were selected as exact, which was verified by numerical computing in PTC Creo Simulate software. The relative percentage errors are graphically interpreted, and the contribution also deals with the creation of limiting conditions for their use. The aim is to point at limiting conditions of using this method, which may not be always met in practice. It also points to possible failures of this method, which is shown in an incorrect dimension of the shaft, influencing the reliability and safety of operation.
Ključne riječi
deformation; errors relative percentage; shaft deflection; step shaft
Hrčak ID:
167493
URI
Datum izdavanja:
13.10.2016.
Posjeta: 2.378 *