hrcak mascot   Srce   HID

Metalurgija, Vol. 55 No. 3, 2016.

Prethodno priopćenje

Friction stir welding (FSW) of aluminium foam sandwich panels

M. Bušić ; Faculty of Mechanical Engineering and Naval Architecture, University of Zagreb, Zagreb, Croatia
Z. Kožuh ; Faculty of Mechanical Engineering and Naval Architecture, University of Zagreb, Zagreb, Croatia
D. Klobčar ; Faculty of Mechanical Engineering, University of Ljubljana, Ljubljana, Slovenia
I. Samardžić ; Mechanical Engineering Faculty, University of Osijek, Slavonski Brod, Croatia

Puni tekst: engleski, pdf (269 KB) str. 473-476 preuzimanja: 472* citiraj
APA 6th Edition
Bušić, M., Kožuh, Z., Klobčar, D. i Samardžić, I. (2016). Friction stir welding (FSW) of aluminium foam sandwich panels. Metalurgija, 55 (3), 473-476. Preuzeto s https://hrcak.srce.hr/153688
MLA 8th Edition
Bušić, M., et al. "Friction stir welding (FSW) of aluminium foam sandwich panels." Metalurgija, vol. 55, br. 3, 2016, str. 473-476. https://hrcak.srce.hr/153688. Citirano 21.02.2019.
Chicago 17th Edition
Bušić, M., Z. Kožuh, D. Klobčar i I. Samardžić. "Friction stir welding (FSW) of aluminium foam sandwich panels." Metalurgija 55, br. 3 (2016): 473-476. https://hrcak.srce.hr/153688
Harvard
Bušić, M., et al. (2016). 'Friction stir welding (FSW) of aluminium foam sandwich panels', Metalurgija, 55(3), str. 473-476. Preuzeto s: https://hrcak.srce.hr/153688 (Datum pristupa: 21.02.2019.)
Vancouver
Bušić M, Kožuh Z, Klobčar D, Samardžić I. Friction stir welding (FSW) of aluminium foam sandwich panels. Metalurgija [Internet]. 2016 [pristupljeno 21.02.2019.];55(3):473-476. Dostupno na: https://hrcak.srce.hr/153688
IEEE
M. Bušić, Z. Kožuh, D. Klobčar i I. Samardžić, "Friction stir welding (FSW) of aluminium foam sandwich panels", Metalurgija, vol.55, br. 3, str. 473-476, 2016. [Online]. Dostupno na: https://hrcak.srce.hr/153688. [Citirano: 21.02.2019.]

Sažetak
The article focuses on the influence of welding speed and tool tilt angle upon the mechanical properties at the friction stir welding of aluminium foam sandwich panels. Double side welding was used for producing butt welds of aluminium sandwich panels applying insertion of extruded aluminium profile. Such insertion provided lower pressure of the tool upon the aluminium panels, providing also sufficient volume of the material required for the weldment formation. Ultimate tensile strength and flexural strength for three-point bending test have been determined for samples taken from the welded joints. Results have confirmed anticipated effects of independent variables.

Ključne riječi
friction stir welding; aluminium foam; welding speed; sandwich panels; tool tilt angle

Hrčak ID: 153688

URI
https://hrcak.srce.hr/153688

Posjeta: 639 *