hrcak mascot   Srce   HID

Prethodno priopćenje

Measurement of casting parameters in ZnAlCu3 molds created by additive technology

S. Medić ; University of Applied Sciences, Karlovac, Croatia
J. Groš ; University of Applied Sciences, Karlovac, Croatia
A. Horvatić ; Faculty of Mechanical Engineering and Naval Architecture, Zagreb, Croatia
Ž. Kondić ; University North, Varaždin,Croatia
L. Maglić ; Faculty of Mechanical Engineering in Slavonski Brod, University of Osijek, Croatia

Puni tekst: engleski, pdf (277 KB) str. 705-708 preuzimanja: 221* citiraj
APA 6th Edition
Medić, S., Groš, J., Horvatić, A., Kondić, Ž. i Maglić, L. (2016). Measurement of casting parameters in ZnAlCu3 molds created by additive technology. Metalurgija, 55 (4), 705-708. Preuzeto s https://hrcak.srce.hr/157429
MLA 8th Edition
Medić, S., et al. "Measurement of casting parameters in ZnAlCu3 molds created by additive technology." Metalurgija, vol. 55, br. 4, 2016, str. 705-708. https://hrcak.srce.hr/157429. Citirano 11.12.2019.
Chicago 17th Edition
Medić, S., J. Groš, A. Horvatić, Ž. Kondić i L. Maglić. "Measurement of casting parameters in ZnAlCu3 molds created by additive technology." Metalurgija 55, br. 4 (2016): 705-708. https://hrcak.srce.hr/157429
Harvard
Medić, S., et al. (2016). 'Measurement of casting parameters in ZnAlCu3 molds created by additive technology', Metalurgija, 55(4), str. 705-708. Preuzeto s: https://hrcak.srce.hr/157429 (Datum pristupa: 11.12.2019.)
Vancouver
Medić S, Groš J, Horvatić A, Kondić Ž, Maglić L. Measurement of casting parameters in ZnAlCu3 molds created by additive technology. Metalurgija [Internet]. 2016 [pristupljeno 11.12.2019.];55(4):705-708. Dostupno na: https://hrcak.srce.hr/157429
IEEE
S. Medić, J. Groš, A. Horvatić, Ž. Kondić i L. Maglić, "Measurement of casting parameters in ZnAlCu3 molds created by additive technology", Metalurgija, vol.55, br. 4, str. 705-708, 2016. [Online]. Dostupno na: https://hrcak.srce.hr/157429. [Citirano: 11.12.2019.]

Sažetak
This paper examines the parameters of casting ZnAl4Cu3 alloy (volume, castability, density and occupancy of the mold) in mold made additive technology. Molds made by additive technology are: cheaper in production of a small number of castings, geometrically more accurate and faster made. From obtained results of this paper it is clearly seen that printed mold must be protected with thermal coating because liquid adhesive of powder otherwise evaporates during casting and creates additional moisture in the mold, as it was noted.

Ključne riječi
casting; ZnAlCu3; additive technology; zirconium dioxide coating

Hrčak ID: 157429

URI
https://hrcak.srce.hr/157429

Posjeta: 336 *