hrcak mascot   Srce   HID

Izvorni znanstveni članak

Influence of ploughshare surface layers on ploughing efficiency

Z. Horvat ; Faculty of Mechanical Engineering in Slavonski Brod of J. J. Strossmayer University of Osijek
V. Marušić ; Faculty of Mechanical Engineering in Slavonski Brod of J. J. Strossmayer University of Osijek
I. Samardžić ; Faculty of Mechanical Engineering in Slavonski Brod of J. J. Strossmayer University of Osijek
I. Opačak ; Faculty of Mechanical Engineering in Slavonski Brod of J. J. Strossmayer University of Osijek

Puni tekst: engleski, pdf (224 KB) str. 125-127 preuzimanja: 224* citiraj
APA 6th Edition
Horvat, Z., Marušić, V., Samardžić, I. i Opačak, I. (2018). Influence of ploughshare surface layers on ploughing efficiency. Metalurgija, 57 (1-2), 125-127. Preuzeto s https://hrcak.srce.hr/189381
MLA 8th Edition
Horvat, Z., et al. "Influence of ploughshare surface layers on ploughing efficiency." Metalurgija, vol. 57, br. 1-2, 2018, str. 125-127. https://hrcak.srce.hr/189381. Citirano 22.01.2020.
Chicago 17th Edition
Horvat, Z., V. Marušić, I. Samardžić i I. Opačak. "Influence of ploughshare surface layers on ploughing efficiency." Metalurgija 57, br. 1-2 (2018): 125-127. https://hrcak.srce.hr/189381
Harvard
Horvat, Z., et al. (2018). 'Influence of ploughshare surface layers on ploughing efficiency', Metalurgija, 57(1-2), str. 125-127. Preuzeto s: https://hrcak.srce.hr/189381 (Datum pristupa: 22.01.2020.)
Vancouver
Horvat Z, Marušić V, Samardžić I, Opačak I. Influence of ploughshare surface layers on ploughing efficiency. Metalurgija [Internet]. 2018 [pristupljeno 22.01.2020.];57(1-2):125-127. Dostupno na: https://hrcak.srce.hr/189381
IEEE
Z. Horvat, V. Marušić, I. Samardžić i I. Opačak, "Influence of ploughshare surface layers on ploughing efficiency", Metalurgija, vol.57, br. 1-2, str. 125-127, 2018. [Online]. Dostupno na: https://hrcak.srce.hr/189381. [Citirano: 22.01.2020.]

Sažetak
The paper presents comparison between standard ploughshares made of manganese steel 50Mn7 and the authors’ ploughshares hardfaced with a layer of C-Co-Cr-Ni-Si on the same steel. The research was carried out by using two tractors with two four-furrow plough of the same power in a total of 360 working hours, and a total of 180 hours of ploughing with each ploughshare. Ploughshares were used to measure hardness, to analyse the structure and wear.

Ključne riječi
alloy steel; ploughing; surface layer; wear; efficiency

Hrčak ID: 189381

URI
https://hrcak.srce.hr/189381

Posjeta: 337 *