hrcak mascot   Srce   HID

Prethodno priopćenje

Design of experiment’s application in the optimization of milling process

D. Bajić ; Faculty of Electrical Engineering, Mechanical Engineering and Naval Architecture, University of Split, Split, Croatia
S. Jozić ; Faculty of Electrical Engineering, Mechanical Engineering and Naval Architecture, University of Split, Split, Croatia
S. Podrug ; Faculty of Electrical Engineering, Mechanical Engineering and Naval Architecture, University of Split, Split, Croatia

Puni tekst: engleski, pdf (286 KB) str. 123-126 preuzimanja: 1.359* citiraj
APA 6th Edition
Bajić, D., Jozić, S. i Podrug, S. (2010). Design of experiment’s application in the optimization of milling process. Metalurgija, 49 (2), 123-126. Preuzeto s https://hrcak.srce.hr/43656
MLA 8th Edition
Bajić, D., et al. "Design of experiment’s application in the optimization of milling process." Metalurgija, vol. 49, br. 2, 2010, str. 123-126. https://hrcak.srce.hr/43656. Citirano 20.09.2019.
Chicago 17th Edition
Bajić, D., S. Jozić i S. Podrug. "Design of experiment’s application in the optimization of milling process." Metalurgija 49, br. 2 (2010): 123-126. https://hrcak.srce.hr/43656
Harvard
Bajić, D., Jozić, S., i Podrug, S. (2010). 'Design of experiment’s application in the optimization of milling process', Metalurgija, 49(2), str. 123-126. Preuzeto s: https://hrcak.srce.hr/43656 (Datum pristupa: 20.09.2019.)
Vancouver
Bajić D, Jozić S, Podrug S. Design of experiment’s application in the optimization of milling process. Metalurgija [Internet]. 2010 [pristupljeno 20.09.2019.];49(2):123-126. Dostupno na: https://hrcak.srce.hr/43656
IEEE
D. Bajić, S. Jozić i S. Podrug, "Design of experiment’s application in the optimization of milling process", Metalurgija, vol.49, br. 2, str. 123-126, 2010. [Online]. Dostupno na: https://hrcak.srce.hr/43656. [Citirano: 20.09.2019.]

Sažetak
This paper examines the influence of cutting parameters on surface roughness of steel workpiece. The experiments have been carried out in accordance with a design of experiments (DOE). Equation for the surface roughness, as a function of cutting parameters, has been obtained by means of regression analysis. To obtain the minimal value of surface roughness, the equation optimizing was performed by using partial derivations and solving system of equations. The Taguchi method, with orthogonal arrays and signal to noise ratio, has been used to analyze impact of various cutting parameters on surface roughness and to find optimal levels of the cutting parameters. The comparison of results obtained by means of the response surface method and the Taguchi
method was performed.

Ključne riječi
face milling; surface roughness; design of experiments; regression analysis; Taguchi method

Hrčak ID: 43656

URI
https://hrcak.srce.hr/43656

[hrvatski]

Posjeta: 1.704 *