Izvorni znanstveni članak
https://doi.org/10.7305/automatika.2017.03.1766
Modeling and Control of Bulk Material Flow on the Electromagnetic Vibratory Feeder
Petar Mišljen
orcid.org/0000-0003-4685-9729
; University of Kragujevac, Faculty of Engineering, Centre for Applied Automatic Control, 6, Sestre Janjic Str, 34000 Kragujevac, Serbia
Željko Despotović
orcid.org/0000-0003-2977-6710
; University of Belgrade, Mihajlo Pupin Institute, Department of Robotics and Mechatronics 15, Volgina Str, 11000 Belgrade, Serbia
Milan Matijević
; University of Kragujevac, Faculty of Engineering, Centre for Applied Automatic Control, 6, Sestre Janjic Str, 34000 Kragujevac, Serbia
Sažetak
This paper presents the results of modeling, simulation and experimental research of the bulk material flow on the electromagnetic vibratory feeder (EVF). The model of the EVF was implemented in Simulink/Matlab and verified in the experimental research. It has been experimentally confirmed that the bulk material flow rate has its maximal value as far as excitation frequency is equal to the EVF mechanical resonant frequency. For certain bulk material flow rate, average value of excitation coil current of EVF has minimal value when named frequencies are equal. In addition to modeling of the EVF, the main contribution of this paper is implementation of flow control algorithm of bulk material on EVF, experimental verification of the adopted model and defines parameters that enable the selection of energy-efficient operating point of the EVF.
Ključne riječi
Actuator; Power Converter; Electromagnetic excitation; Frequency; PWM; Vibratory feeder; Flow control
Hrčak ID:
196092
URI
Datum izdavanja:
19.1.2018.
Posjeta: 2.415 *