Drvna industrija, Vol. 72 No. 2, 2021.
Izvorni znanstveni članak
https://doi.org/10.5552/drvind.2021.1946
Effect of Soaking/Oven- Drying on Mechanical and Physical Properties of Birch (Betula spp.) Plywood
Regino Kask
; Estonian University of Life Sciences, Institute of Forestry and Rural Engineering, Tartu, Estonia
Harri Lille
; Estonian University of Life Sciences, Institute of Forestry and Rural Engineering, Tartu, Estonia
Mihkel Kiviste
orcid.org/0000-0001-8726-070X
; Estonian University of Life Sciences, Institute of Forestry and Rural Engineering, Tartu, Estonia; Author is researcher at Tallinn University of Technology, Tartu College, School of Engineering, Tartu, Estonia
Silver Kruus
; Estonian University of Life Sciences, Institute of Forestry and Rural Engineering, Tartu, Estonia
Johann Olaf Lääne
; Estonian University of Life Sciences, Institute of Technology, Tartu, Estonia
Sažetak
The objective of this study was to explore some of the physical and mechanical properties of 9-layer birch (Betula spp.) plywood with the addition of phenol-formaldehyde glue, in cases in which the cutting edges of the samples are coated with the damp-proof mastic Fibergum, and in case in which they remain unprocessed (uncoated), following a total of ten cycles of soaking/oven-drying. The properties to be determined were the bending strength (BS), modulus of elasticity in bending (MOE), thickness swelling (TS) and restore dimensions (RD), which were tested according to the European standards (EN). A linear-fractional equation and linear relationship were used for the approximation of any change in the physical and mechanical properties of the samples depending upon the number of soaking/oven-drying cycles. It was shown that the values of the properties investigated were most affected by the first soaking and drying cycle. Thereafter, BS and MOE levels decreased smoothly at a low rate, but the values of TS became stabilised. The BS and MOE values for the wet samples with coated cutting edges were higher than when they were uncoated, as the moisture levels in the former case were lower. After the first soaking of the samples with coated cutting edges, the retention values were as follows: BS at 52.8 % and 66.7 % for the major and minor axes, respectively, with the same applying to MOE at 61.9 % and 64.2 %, while TS was at 105.2 %. To clarify the phenomenon that causes a decrease of the properties, the face plies and edge structures of the initial dry samples and of the samples after the first, second and ninth soaking/oven-drying cycles were studied using the X-Ray technique.
Ključne riječi
plywood; bending strength; modulus of elasticity; thickness swelling; restore dimensions; moisture content; X-Ray technique
Hrčak ID:
257206
URI
Datum izdavanja:
7.5.2021.
Posjeta: 1.524 *