Izvorni znanstveni članak
https://doi.org/10.31534/engmod.2021.2.ri.01m
Calibration of an Existing Creep Model for Analysis of Aluminium Members Exposed to Constant Temperature
Marko Goreta
orcid.org/0000-0001-7645-1623
; University of Split, Faculty of Civil Engineering, Architecture and Geodesy, Matice hrvatske 15, 21000 Split, CROATIA
Neno Torić
orcid.org/0000-0003-2282-8362
; University of Split, Faculty of Civil Engineering, Architecture and Geodesy, Matice hrvatske 15, 21000 Split, CROATIA
Ivica Boko
orcid.org/0000-0003-2282-8362
; University of Split, Faculty of Civil Engineering, Architecture and Geodesy, Matice hrvatske 15, 21000 Split, CROATIA
Sažetak
The paper presents the development of a creep model applicable for the analysis of aluminium members exposed to a constant temperature. The model is intended as a base for defining a creep model in a transient heating regime. The behaviour of aluminium members exposed to the transient heating regime is a relatively unexplored topic in the scientific community. There is a need for defining an advanced creep model for aluminium, which should cover any heating regime to model the influence of creep on members exposed to fire. A comparison of results between the existing experimental data and the built-in creep models from commercial software ANSYS 16.2 for specific temperature and stress levels is provided. The experimental data used was extracted from previous tests carried out on coupons of aluminium alloy EN 6082 AW T6 and fitted in the aforementioned ANSYS models which serve as a base for defining the representative advanced creep model.
Ključne riječi
aluminium; creep; fire; column; coupon; tests; EN 6082 AW T6; ANSYS 16.2
Hrčak ID:
259694
URI
Datum izdavanja:
25.11.2021.
Posjeta: 1.687 *