Prethodno priopćenje

https://doi.org/10.17559/TV-20210625150328

Design Principle for Additive Manufacturing: Direct Metal Sintering

Regina Novak orcid.org/0009-0007-5440-0949 ; Faculty of Mechanical Engineering and Naval Architecture, Ivana Lučića 5, 10000 Zagreb, Croatia
Filip Valjak orcid.org/0000-0001-6151-9453 ; Faculty of Mechanical Engineering and Naval Architecture, Ivana Lučića 5, 10000 Zagreb, Croatia
Nenad Bojčetić orcid.org/0000-0001-7353-0537 ; Faculty of Mechanical Engineering and Naval Architecture, Ivana Lučića 5, 10000 Zagreb, Croatia
Mario Šercer orcid.org/0000-0002-4101-4092 ; Development and Educational Centre for the Metal Industry - Metal Centre Čakovec, Bana Josipa Jelačića 22 D, 40000 Čakovec, Croatia

Sažetak

Additive Manufacturing (AM) brought new design possibilities and freedom to the product design process. However, as the existing design rules and design limitations do not apply to the AM, designers require new methods and tools to utilise the full potential of AM. The stated is especially noticeable in the design of metal products made with AM, particularly with the Direct Metal Laser Sintering (DMLS) process. The research proposes a methodological approach for analysing the existing DMLS products made with DMLS to extract design knowledge. The methodology is applied to the pool of DMLS from which 15 design principles are extracted that formalise design knowledge about DMLS. The design principles are intended to be used in the early design stages of the design process as a source of design knowledge and inspiration for conceptualising new and innovative products that will be made using DMLS.

Ključne riječi

AM models; design for additive manufacturing; design principles; direct metal laser sintering; metal AM

Hrčak ID:

300705

URI

https://hrcak.srce.hr/300705

Datum izdavanja:

23.4.2023.

Posjeta: 478 *